First off, let’s keep it clear: the
Chery FX Inner Rear Tail Lamp 605000724AA isn’t just a “back light”—it’s the “inner signal light” for your FX’s rear end. Think of it as the smaller, center-side tail lamp that sits
inside the
rear bumper (or closer to the car’s body, next to the outer tail lamps) and works with the outer ones to send clear signals to other drivers. It doesn’t just light up—it keeps you safe by showing when you’re braking, turning, or just driving at night. Without it, other cars might miss your moves (like a left turn or slowing down) in dark or rainy weather—total safety risk.
This inner rear tail lamp is only for Chery FX models (always double-check your car’s VIN or owner’s manual to confirm!). It’s built to fit the FX’s rear body exactly: the shape matches the car’s rear bumper cutout (no gaps or weird overhangs), the mounting holes line up with the pre-drilled spots, and the wiring plug connects straight to your FX’s existing rear light harness—no cutting or splicing needed. Grab a generic one? You’ll run into headaches: it’s too big/small (won’t fit the bumper), the plug doesn’t match (can’t connect), or the light colors are off (braking light looks dim). Total hassle for a part that’s supposed to keep you safe.
![605000724AA]( "605000724AA")
This 605000724AA inner rear tail lamp only works with Chery FX models—using the wrong one wastes money and risks safety:
Fits These Models: Chery FX (all trims; confirm via VIN to match your lamp type—bulb or LED variant).
Won’t Fit These:
Other Chery models (e.g., Tiggo 7, Arrizo 6): Their rear bumpers and light harnesses are different—this lamp won’t fit or connect.
Non-Chery vehicles (e.g., Geely Emgrand): Even if it “looks close,” the mounting and plug are wrong—you’ll damage the wiring trying to install it.
Trim Compatibility: Works with both bulb-type and LED-type FX rear light setups (check your original lamp—if it uses a bulb, this one does too; if it’s LED, this matches that). Aftermarket LED kits may not pair with it—stick to factory-style bulbs/LEDs.
You don’t need a mechanic—just a screwdriver. Here’s how:
Access the lamp: Open your FX’s trunk, and find the small panel behind the inner rear tail lamp (usually held by clips). Pop the panel off to see the lamp’s back.
Unplug the wiring: Gently pull the lamp’s plug out of the car’s harness (it clicks, so give it a firm tug).
Remove the old lamp: Unscrew the 2–3 bolts holding the lamp to the bumper (use a Phillips or flathead screwdriver). Pull the old lamp out.
Install the new one: Slide the 605000724AA lamp into the bumper cutout, screw it back in, and plug the wiring back in. Test the light (brake, turn signal) to make sure it works.
![605000724AA]( "605000724AA")
The Chery FX Inner Rear Tail Lamp 605000724AA fits only Chery FX models (confirm via VIN for bulb/LED trim match). It boosts safety by signaling braking, turns, and marking the car at night—working with outer lamps for clear visibility.
Made with UV-resistant, tough housing and a waterproof rubber gasket (prevents leaks), it uses the FX’s original bulb/LED and plugs directly into the wiring (no splicing). DIY-installable in 10 minutes (screwdriver needed). Maintain by cleaning the lens and replacing bulbs/gaskets as needed. Aftermarket versions are dim/leaky; the original is reliable and avoids safety risks.
![605000724AA]( "605000724AA")
Contact us
![605000724AA]( "605000724AA")
